JZM350 Concrete Mixer

Production Description

Workflow of JZM350: First, the aggregate is poured into the lifting hopper, the lifting hopper rises to the upper feed rack, and the material is discharged into the drum. Second, the mixing motor drives the reducer and the rubber belt to rotate the drum. Third, forward feed, reverse discharging, water pump supplies water to the mixing drum. Finally, high-pressure water gun to clean the inside of the drum.

JZM350 is applicable to general construction sites, roads and concrete component plants. JZM350 is mainly used to mix general plastic concrete. It is widely used, simple in structure, small in power required, convenient in operation, easy in maintenance, suitable for scattered or centralized use on the site, and easy to move.

JZM350 concrete mixer is composed of feeding mechanism, mixing mechanism, transmission mechanism, water supply mechanism, chassis and electric control system.

Operation precautions of JZ Series:

1.  Each time mixing materials are added. The specified value shall not be exceeded. And the hopper can only be lifted for feeding after the discharge in the mixing drum is completed.

2. The hopper shall not be lowered at will. When it is necessary to lower under special circumstances, the brake must be used for slow and balanced descent.   

3. In order to reduce the sticking of the hopper, the sequence of adding aggregate to the hopper shall be gravel cement sand, or sand cement gravel.   

4. In the process of feeding, water shall be added in time to reduce the time of extraction and dust.    

5. When the hopper is lifted, no one is allowed to stay under the hopper. Empty hopper shall be lowered slowly. To increase the service life of the machine.

6. The handle of the operating lever shall not be pulled at will by non operators.      

7. Pay attention to the electrical safety, prevent the motor from being damped, and prevent the electrical components and wires from being damaged.      

8. In case of power failure, the materials in the cylinder can be discharged by cranking the reducer pulley.   

9. Gear ring and rail must be lubricated with oil (machine oil) every shift.    

Warning: If the universal change-over switch is in the mixing (or discharging) position, it is strictly prohibited to quickly turn it to the discharging (or mixing) position to avoid damaging the gear of the reducer.